How to change the port Snapt runs on?

If you are using a Snapt bundle or VM image you will notice it runs on port 8080 by default. This can be undesirable as you may want to use that port. You can edit the file /usr/local/snapt/etc/lighttpd.conf or, if you are using our image, /etc/lighttpd/lighttpd.conf and you will see the port setting as shown below —

# Server config

server.port = 8080

Change that to what you want, and then run the following —

 

killall lighttpd

/usr/local/snapt/start.sh

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.